Yamaha FX10X Service Manual page 218
Hide thumbs
Also See for FX10X:
- Service manual (727 pages) ,
- Assembly manual (152 pages) ,
- Owner's manual (92 pages)
Advertisement
a
b
3
2
1
È
C
a
2
3
É
C
1
STEERING
INSTALLATION
1. Install:
• Tie rod 1
• Locknuts 2
• Joints 3
È Tie rod part
number
8GL-23830-00
(FX10/FX10RT/
FX10RTR/
FX10RTRA)
8HA-23830-00
(FX10MT/
FX10MTR/
FX10MTRA)
2. Check:
• Tie rod angle c
Tie rod angle:
32°
CAUTION:
After tightening the inside and outside ball joint
locknut 2, make sure the tie rod 1 can be
rotated freely through the ball joint travel. If not,
loosen the locknut 2 and re-position the ball
joint so that the tie rod 1 can be rotated freely.
Tighten the locknut to specification.
È Left side
É Right side
3. Install:
• Tie rods 1
NOTE:
Make sure that the indentation a on the tie rod
faces out.
CAUTION:
Always use new cotter pins.
Tie rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
Tie rod and pivot arm nut:
35 Nm (3.5 m · kg, 25 ft · lb)
Tie rod and steering knuckle nut:
28 Nm (2.8 m · kg, 20 ft · lb)
3-12
CHAS
É Set length
Ê Tie rod
a
length b
544.0 mm
475.5 mm
(21.42 in)
(18.72 in)
518.0 mm
449.5 mm
(20.39 in)
(17.70 in)
®
- Quick Links:
- Valve Clearance Adjustment
Hide quick links:
Advertisement
Chapters
Troubleshooting
