Yamaha FX10X Service Manual page 440

Hide thumbs Also See for FX10X:

CYLINDER HEAD

• Tighten the cylinder head bolts further to reach

the specified angle 175 ~ 185° in the proper

tightening sequence as shown.

Cylinder head bolt (M10):

Specified angle 175 ~ 185°

When the bolts are tightened more than the

specified angle, do not loosen the bolt and then

retighten it.

Replace the bolt with a new one and perform

the procedure again.

• Do not use a torque wrench to tighten the bolt

to the specified angle.

• Tighten the bolt until it is at the specified

When using a hexagonal bolt, note that the angle

from one corner to another is 60°.

• Cylinder head bolts (M6) 1

Cylinder head bolt:

12 Nm (1.2 m · kg, 8.7 ft · lb)

Show Quick Links

Chapters