Dot1X Auth-Fail Max-Attempts - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
dot1x auth-fail max-attempts
Use the dot1x auth-fail max-attempts interface configuration command to configure the maximum
allowable authentication attempts before a port is moved to the restricted VLAN. To return to the default
setting, use the no form of this command.
Syntax Description
max-attempts
Defaults
The default value is 3 attempts.
Command Modes
Interface configuration
Command History
Release
12.2(25)SEF
Usage Guidelines
If you reconfigure the maximum number of authentication attempts allowed by the VLAN, the change
takes effect after the re-authentication timer expires.
Examples
This example shows how to set 2 as the maximum number of authentication attempts allowed before the
port is moved to the restricted VLAN on port 23:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet0/23
Switch(config-if)# dot1x auth-fail max-attempts 2
Switch(config-if)# end
Switch(config)# end
Switch#
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
OL-8916-01
dot1x auth-fail max-attempts max-attempts
no dot1x auth-fail max-attempts
Specify a maximum number of authentication attempts allowed before a port
is moved to the restricted VLAN. The range is 1 to 3, the default value is 3.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
dot1x auth-fail max-attempts
2-57
Advertisement
Table of Contents
