Debug Qos-Manager - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3020 for HP Debug Commands
debug qos-manager
Use the debug qos-manager privileged EXEC command to enable debugging of the quality of service
(QoS) manager software. Use the no form of this command to disable debugging.
Syntax Description
all
event
verbose
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)SEF
Usage Guidelines
The undebug qos-manager command is the same as the no debug qos-manager command.
Related Commands
Command
show debugging
OL-8916-01
debug qos-manager {all | event | verbose}
no debug qos-manager {all | event | verbose}
Display all QoS-manager debug messages.
Display QoS-manager related-event debug messages.
Display QoS-manager detailed debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
debug qos-manager
B-59
Advertisement
Table of Contents
