Mac Access-List Extended - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
mac access-list extended
Use the mac access-list extended global configuration command to create an access list based on MAC
addresses for non-IP traffic. Using this command puts you in the extended MAC access-list
configuration mode. Use the no form of this command to return to the default setting.
name
Syntax Description
Defaults
By default, there are no MAC access lists created.
Command Modes
Global configuration
Command History
Release
12.2(25)SEF
Usage Guidelines
MAC named extended lists are used with VLAN maps and class maps.
You can apply named MAC extended ACLs to VLAN maps or to Layer 2 interfaces.
Entering the mac access-list extended command enables the MAC access-list configuration mode.
These configuration commands are available:
•
•
•
•
•
For more information about MAC extended access lists, see the software configuration guide for this
release.
OL-8916-01
mac access-list extended name
no mac access-list extended name
Assign a name to the MAC extended access list.
Modification
This command was introduced.
default: sets a command to its default.
deny: specifies packets to reject. For more information, see the
configuration)
MAC access-list configuration command.
exit: exits from MAC access-list configuration mode.
no: negates a command or sets its defaults.
permit: specifies packets to forward. For more information, see the
configuration)
command.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
mac access-list extended
deny (MAC access-list
permit (MAC access-list
2-151
Advertisement
Table of Contents
