Debug Platform Sw-Bridge - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3020 for HP Debug Commands
debug platform sw-bridge
Use the debug platform sw-bridge privileged EXEC command to enable debugging of the software
bridging function. Use the no form of this command to disable debugging.
Syntax Description
broadcast
control
multicast
packet
unicast
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)SEF
Usage Guidelines
The undebug platform sw-bridge command is the same as the no debug platform sw-bridge
command.
Related Commands
Command
show debugging
OL-8916-01
debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
no debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
Display broadcast-data debug messages.
Display protocol-packet debug messages.
Display multicast-data debug messages.
Display sent and received data debug messages.
Display unicast-data debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
debug platform sw-bridge
B-51
Advertisement
Table of Contents
