Cisco 3020 - Catalyst Blade Switch Command Reference Manual page 106
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
dot1x port-control
•
•
To globally disable IEEE 802.1x authentication on the switch, use the no dot1x system-auth-control
global configuration command. To disable IEEE 802.1x authentication on a specific port or to return to
the default setting, use the no dot1x port-control interface configuration command.
Examples
This example shows how to enable IEEE 802.1x authentication on a port:
Switch(config)# interface gigabitethernet0/21
Switch(config-if)# dot1x port-control auto
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Command
show dot1x
Cisco Catalyst Blade Switch 3020 for HP Command Reference
2-78
EtherChannel port—Do not configure a port that is an active or a not-yet-active member of an
EtherChannel as an IEEE 802.1x port. If you try to enable IEEE 802.1x authentication on an
EtherChannel port, an error message appears, and IEEE 802.1x authentication is not enabled.
Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) destination ports—You can enable
IEEE 802.1x authentication on a port that is a SPAN or RSPAN destination port. However,
IEEE 802.1x authentication is disabled until the port is removed as a SPAN or RSPAN destination.
You can enable IEEE 802.1x authentication on a SPAN or RSPAN source port.
[interface interface-id]
Chapter 2
Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
Description
Displays IEEE 802.1x status for the specified port.
OL-8916-01
Advertisement
Table of Contents
