Mls Qos Trust - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
mls qos trust
Use the mls qos trust interface configuration command to configure the port trust state. Ingress traffic
can be trusted, and classification is performed by examining the packet Differentiated Services Code
Point (DSCP), class of service (CoS), or IP-precedence field. Use the no form of this command to return
a port to its untrusted state.
Syntax Description
cos
device cisco-phone
dscp
ip-precedence
Defaults
The port is not trusted. If no keyword is specified when the command is entered, the default is dscp.
Command Modes
Interface configuration
Command History
Release
12.2(25)SEF
Usage Guidelines
Packets entering a quality of service (QoS) domain are classified at the edge of the domain. When the
packets are classified at the edge, the switch port within the QoS domain can be configured to one of the
trusted states because there is no need to classify the packets at every switch within the domain. Use this
command to specify whether the port is trusted and which fields of the packet to use to classify traffic.
When a port is configured with trust DSCP or trust IP precedence and the incoming packet is a non-IP
packet, the CoS-to-DSCP map is used to derive the corresponding DSCP value from the CoS value. The
CoS can be the packet CoS for trunk ports or the port default CoS for nontrunk ports.
If the DSCP is trusted, the DSCP field of the IP packet is not modified. However, it is still possible that
the CoS value of the packet is modified (according to DSCP-to-CoS map).
If the CoS is trusted, the CoS field of the packet is not modified, but the DSCP can be modified
(according to CoS-to-DSCP map) if the packet is an IP packet.
OL-8916-01
mls qos trust [cos | device cisco-phone | dscp | ip-precedence]
no mls qos trust [cos | device | dscp | ip-precedence]
(Optional) Classify an ingress packet by using the packet CoS value. For an
untagged packet, use the port default CoS value.
(Optional) Classify an ingress packet by trusting the CoS or DSCP value sent
from the Cisco IP Phone (trusted boundary), depending on the trust setting.
(Optional) Classify an ingress packet by using the packet DSCP value (most
significant 6 bits of 8-bit service-type field). For a non-IP packet, the packet
CoS is used if the packet is tagged. For an untagged packet, the default port
CoS value is used.
(Optional) Classify an ingress packet by using the packet IP-precedence value
(most significant 3 bits of 8-bit service-type field). For a non-IP packet, the
packet CoS is used if the packet is tagged. For an untagged packet, the port
default CoS value is used.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
mls qos trust
2-213
Advertisement
Table of Contents
