Cisco 3020 - Catalyst Blade Switch Command Reference Manual page 669
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3020 for HP Debug Commands
search
write {forw-ram | reg |
tcam}
Note
Though visible in the command-line help strings, the l3 ipv6 {acl {input | output} | local | qos |
secondary}, the l3 local, and the l3 secondary keywords are not supported.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)SEF
Usage Guidelines
The undebug platform tcam command is the same as the no debug platform tcam command.
Related Commands
Command
show debugging
OL-8916-01
Display supervisor-initiated TCAM-search results debug messages.
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
debug platform tcam
B-53
Advertisement
Table of Contents
