Cisco 3020 - Catalyst Blade Switch Command Reference Manual page 61
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 2
Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
Examples
This example shows how to create a policy map called policy1. When attached to the ingress direction,
it matches all the incoming traffic defined in class1, sets the IP Differentiated Services Code Point
(DSCP) to 10, and polices the traffic at an average rate of 1 Mbps and bursts at 20 KB. Traffic exceeding
the profile is marked down to a DSCP value gotten from the policed-DSCP map and then sent.
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# set dscp 10
Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit
Switch(config-pmap-c)# exit
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands
Command
class-map
police
policy-map
set
show policy-map
trust
OL-8916-01
Description
Creates a class map to be used for matching packets to the class whose name
you specify.
Defines a policer for classified traffic.
Creates or modifies a policy map that can be attached to multiple ports to
specify a service policy.
Classifies IP traffic by setting a DSCP or IP-precedence value in the packet.
Displays quality of service (QoS) policy maps.
Defines a trust state for the traffic classified through the class policy-map
configuration command or the class-map global configuration command.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
class
2-33
Advertisement
Table of Contents
