Udld - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
udld
Use the udld global configuration command to enable aggressive or normal mode in the UniDirectional
Link Detection (UDLD) and to set the configurable message timer time. Use the no form of the command
to disable aggressive or normal mode UDLD on all fiber-optic ports.
Syntax Description
aggressive
enable
message time
message-timer-interval
Defaults
UDLD is disabled on all interfaces.
The message timer is set at 60 seconds.
Command Modes
Global configuration
Command History
Release
12.2(25)SEF
Usage Guidelines
UDLD supports two modes of operation: normal (the default) and aggressive. In normal mode, UDLD
detects unidirectional links due to misconnected interfaces on fiber-optic connections. In aggressive
mode, UDLD also detects unidirectional links due to one-way traffic on fiber-optic and twisted-pair links
and due to misconnected interfaces on fiber-optic links. For information about normal and aggressive
modes, see the "Understanding UDLD" section in the software configuration guide for this release.
If you change the message time between probe packets, you are making a trade-off between the detection
speed and the CPU load. By decreasing the time, you can make the detection-response faster but increase
the load on the CPU.
This command affects fiber-optic interfaces only. Use the udld interface configuration command to
enable UDLD on other interface types.
You can use these commands to reset an interface shut down by UDLD:
•
•
•
OL-8916-01
udld {aggressive | enable | message time message-timer-interval}
no udld {aggressive | enable | message}
Enable UDLD in aggressive mode on all fiber-optic interfaces.
Enable UDLD in normal mode on all fiber-optic interfaces.
Configure the period of time between UDLD probe messages on ports that
are in the advertisement phase and are determined to be bidirectional. The
range is 90 seconds.
Modification
This command was introduced.
The udld reset privileged EXEC command to reset all interfaces shut down by UDLD
The shutdown and no shutdown interface configuration commands
The no udld enable global configuration command followed by the udld {aggressive | enable}
global configuration command to re-enable UDLD globally
Cisco Catalyst Blade Switch for HP Command Reference
udld
2-527
Advertisement
Table of Contents
