Switchport Access - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
switchport access
Use the switchport access interface configuration command to configure a port as a static-access or
dynamic-access port. If the switchport mode is set to access, the port operates as a member of the
specified VLAN. If set to dynamic, the port starts discovery of VLAN assignment based on the incoming
packets it receives. Use the no form of this command to reset the access mode to the default VLAN for
the switch.
Syntax Description
vlan vlan-id
vlan dynamic
Defaults
The default access VLAN and trunk interface native VLAN is a default VLAN corresponding to the
platform or interface hardware.
A dynamic-access port is initially a member of no VLAN and receives its assignment based on the packet
it receives.
Command Modes
Interface configuration
Command History
Release
12.2(25)SEF
Usage Guidelines
The no switchport access command resets the access mode VLAN to the appropriate default VLAN for
the device.
The port must be in access mode before the switchport access vlan command can take effect.
An access port can be assigned to only one VLAN.
The VMPS server (such as a Catalyst 6000 series switch) must be configured before a port is configured
as dynamic.
OL-8916-01
switchport access vlan {vlan-id | dynamic}
no switchport access vlan
Configure the interface as a static access port with the VLAN ID of the
access mode VLAN; the range is 1 to 4094.
Specify that the access mode VLAN is dependent on the VLAN Membership
Policy Server (VMPS) protocol. The port is assigned to a VLAN based on
the source MAC address of a host (or hosts) connected to the port. The switch
sends every new MAC address received to the VMPS server to get the VLAN
name to which the dynamic-access port should be assigned. If the port
already has a VLAN assigned and the source has already been approved by
the VMPS, the switch forwards the packet to the VLAN.
Modification
This command was introduced.
Cisco Catalyst Blade Switch for HP Command Reference
switchport access
2-491
Advertisement
Table of Contents
