Cisco 3020 - Catalyst Blade Switch Command Reference Manual page 340
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
show interfaces
trunk
| begin
| exclude
| include
expression
1. coarse wavelength-division multiplexer
2. dense wavelength-division multiplexer
Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
Note
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes
Privileged EXEC
Command History
Release
12.2(25)SEF
Usage Guidelines
The show interfaces capabilities command with different keywords has these results:
•
•
•
•
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples
This is an example of output from the show interfaces command for an interface:
Switch# show interfaces gigabitethernet0/22
GigabitEthernet0/22 is down, line protocol is down
Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Cisco Catalyst Blade Switch 3020 for HP Command Reference
2-314
Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Use the show interface capabilities module 1 to display the capabilities of all interfaces on the
switch. Entering any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
Use the show interface switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Entering any other number is invalid.
reliability 255/255, txload 1/255, rxload 1/255
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
OL-8916-01
Advertisement
Table of Contents
