Service-Policy - Cisco 3020 - Catalyst Blade Switch Command Reference Manual
Cisco catalyst blade switch 3020 for hp command reference, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Configuration manual (712 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
service-policy
service-policy
Use the service-policy interface configuration command on the switch to apply a policy map defined by
the policy-map command to the input of a physical port or a switch virtual interface (SVI). Use the no
form of this command to remove the policy map and port association.
Syntax Description
input policy-map-name
Note
Though visible in the command-line help strings, the history keyword is not supported, and you should
ignore the statistics that it gathers. The output keyword is also not supported.
Defaults
No policy maps are attached to the port.
Command Modes
Interface configuration
Command History
Release
12.2(25)SEF
Usage Guidelines
Policy maps can be configured on physical ports or on SVIs. When VLAN-based quality of service
(QoS) is disabled by using the no mls qos vlan-based interface configuration command on a physical
port, you can configure a port-based policy map on the port. If VLAN-based QoS is enabled by using
the mls qos vlan-based interface configuration command on a physical port, the switch removes the
previously configured port-based policy map. After a hierarchical policy map is configured and applied
on an SVI, the interface-level policy map takes effect on the interface.
You can apply a policy map to incoming traffic on a physical port or on an SVI. You can configure
different interface-level policy maps for each class defined in the VLAN-level policy map. For more
information about hierarchical policy maps, see the "Configuring QoS" chapter in the software
configuration guide for this release.
Classification using a port trust state (for example, mls qos trust [cos | dscp | ip-precedence] and a
policy map (for example, service-policy input policy-map-name) are mutually exclusive. The last one
configured overwrites the previous configuration.
Cisco Catalyst Blade Switch 3020 for HP Command Reference
2-256
service-policy input policy-map-name
no service-policy input policy-map-name
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
Apply the specified policy map to the input of a physical port or an SVI.
OL-8916-01
Advertisement
Table of Contents
