Table of Contents
Advertisement
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
Procedure
Step 1
In Cisco Unified Communications Manager Administration, delete the existing SIP phone from the
Cisco Unified Communications Manager database.
In Cisco Unified Communications Manager Administration, create the phone as an SCCP phone.
Step 2
Save the configuration updates and reset the phone.
Step 3
Step 4
Power cycle the phone.
Deploying a Phone in an SCCP and SIP Environment
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP and in which the
Cisco Unified Communications Manager Auto-Registration parameter is SCCP, perform these general
steps:
1.
2.
3.
4.
Determining the MAC Address for a Cisco Unified IP Phone
Several procedures described in this manual require you to determine the MAC address of a
Cisco Unified IP Phone. You can determine a phone's MAC address in these ways:
•
•
•
OL-15483-01
Set the Cisco Unified Communications Manager Auto Registration Protocol enterprise parameter to
SCCP.
From Cisco Unified Communications Manager Administration, choose System > Enterprise
Parameters.
Install the phones.
Change the Auto Registration Protocol enterprise parameter to SIP.
Auto-register the SIP phones.
From the phone, press the Settings button and select Model Information and look at the
MAC Address field.
Look at the MAC label on the back of the phone.
Display the web page for the phone and click the Device Information hyperlink.
For information about accessing the web page, see the
on page
8-2.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
Determining the MAC Address for a Cisco Unified IP Phone
"Accessing the Web Page for a Phone" section
2-13
Advertisement
Table of Contents
Troubleshooting
