Frame-Relay Lmi-N392Dce - Cisco ASR 9000 Series Command Reference Manual

Aggregation services router

Hide thumbs Also See for ASR 9000 Series:

Table of Contents

frame-relay lmi-n392dce

To set the error threshold on a DCE interface, use the frame-relay lmi-n392dce command in interface

configuration mode. To restore the default setting, use the no form of this command.

frame-relay lmi-n392dce threshold

no frame-relay lmi-n392dce threshold

Syntax Description

Command Default

The DCE error threshold is 3.

Command Modes

Interface configuration (config-if)

Command History

Release 4.0.0

Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes appropriate task

IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator

for assistance.

N392 errors must occur within the number defined by the N393 event count for the link to be declared down.

Therefore, the threshold value for this command must be less than the count value defined in the frame-relay

lmi-n393dce command.

The frame-relay lmi-n392dce command is relevant only when the interface type is data communication

equipment (DCE).

This command is available on Packet-over-SONET/SDH (POS), serial, and multilink interfaces.

The following example shows how to set the Local Management Interface (LMI) failure threshold to 4. The

router acts as a Frame Relay DCE switch:

RP/0/RSP0/CPU0:router(config)# interface pos 0/1/0/1

RP/0/RSP0/CPU0:router(config-if)# frame-relay intf-type dce

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x

Frame Relay Commands on the Cisco ASR 9000 Series Router

Error threshold value. Range is from 1 to 10. Default is 3.

Modification

This command was introduced.

Show Quick Links

Table of Contents