Table of Contents
Advertisement
Attaching the Cable-Management Bracket
Use a level to verify that the tops of the two brackets are level, or use a measuring tape to verify that both
Step 6
brackets are the same distance from the top of the rack rails.
This completes the procedure for installing the chassis in the rack. Proceed to the
Cable-Management Bracket" section on page 8-26
Attaching the Cable-Management Bracket
The cable-management brackets mount to each rack-mount bracket on the chassis to provide
cable-management to both sides of the chassis (parallel with card orientation). These brackets are screw
mounted to the rack-mount brackets to allow easy installation and removal of cables.
The cable-management brackets for the Cisco ASR 1002 Router contain one independent
cable-management "U" type features with four screws and provides cable dressing of each card module
slot.
Note
Make certain that the cable-management bracket "U" type feature is facing upwards when you attach it
to the chassis.
Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1002 Router
in the rack:
Step 1
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1002
Router. The cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
Step 2
Using a Phillips screwdriver, insert the screw through cable-management bracket and into the chassis
rack-mount and tighten the screw.
Note
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-26
Use the package of four screws.
Chapter 8
Cisco ASR 1002 Router Overview and Installation
to continue the installation.
"Attaching the
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
