Table of Contents
Advertisement
Cisco ASR 1002-X Router Power Supplies
Figure 10-31
Figure 10-31
1
1
Positive lead wire
2
Negative lead wire
Note
After inserting the ground wire, leave an extra service loop in the ground lead, as shown in
Step 9
to ensure that the ground lead is the last lead to disconnect from the power supply if a great deal of strain
is placed on all three leads.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
10-42
shows all the lead wires installed.
Cisco +24 VDC Power Supply Terminal Block with Lead Wires Installed
O U T P U
T IN P U
T
F A N
F A IL
O K
O K
T h is u n
it m ig h t
h a ve m
o n e p o w
o re th a n
e r su p p
A ll co n n
ly co n n
e ct io n .
e ct io n s
m u st b e
to d e -e n
e rg iz e th
re m o ve
d
e u n it.
+ 2 7 V D
C IN P U
T
+ 2 7 V
3 2 A
2
3
Ensure that the stripped end of each lead wire is twisted tightly together. This makes insertion
easier. Also ensure that the entire lead wire is inserted all the way into its receptacle. If exposed
wire is visible at the stripped end of a lead after inserting the lead into its receptacle, remove the
lead from the receptacle, use the wire stripper to cut the stripped end of the lead, and then
reinsert.
Chapter 10
Cisco ASR 1002-X Router Overview and Installation
3
Ground lead wire
— —
Figure 10-32
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router