Table of Contents
Advertisement
Rack-Mounting the Cisco ASR 1002 Router
Note
Figure 8-10
1
2
Screw the cable-management bracket to each side of the rack-mount brackets already attached to the
Step 6
chassis. Use two screws for each cable-management bracket. Use the package of four screws.
Check that all screws are securely tightened.
Step 7
Go to the
Step 8
Rack-Mounting the Cisco ASR 1002 Router
The Cisco ASR 1002 Router can be installed in an existing rack with equipment or in an empty rack with
no equipment: The chassis can be mounted in either rack types:
•
•
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-18
Make certain that the cable-management 'U' feature device has the open end pointing upwards
when you attach it to the chassis
Attaching the Cable-Management Brackets to the Cisco ASR 1002 Router
3
2
Cable-management bracket top and bottom
screw
Cable-management bracket
"Attaching a Chassis Ground Connection" section on page 8-27
Two-post rack, either 19 inch or 23 inch. Inner clearance (the width between the inner sides of the
two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches
(8.8 cm). Airflow through the chassis is from front to back.
If you are using a two-post rack secure the rack to the floor surface to prevent tipping and
Note
avoid bodily.
Four post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches (8.8
cm). Airflow through the chassis is from front to back.
Chapter 8
1
CON
AUX
MGM T
LINK
MTS
CAR RIER
BOO T
QE3
QE2
QE1
STA T
QE0
AS R 10 02
mi n
sta t
ma j
pw r
OS
SPA -4XO C3-P
cri t
1
3
Chassis front rack-mount bracket
—
—
Cisco ASR 1002 Router Overview and Installation
OS
SPA -4XO C3-P
PWR STA
T
SPA -4XO C3-P
OS
to continue the installation.
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
