Table of Contents
Advertisement
Removing and Replacing the Cisco ASR 1000 Series DIMM Memory Modules
With a wrist strap on, loosen the two captive screws on the faceplate of the Cisco ASR 1000 Series RP.
Step 1
Using the handles on both sides of the module, with two hands gently slide the module out of the chassis
Step 2
slot.
Place the route processor on an antistatic mat or pad and ensure that you are wearing an antistatic device,
Step 3
such as a wrist strap.
Position the route processor so that the faceplate is toward you and the edge connector is away from you.
Step 4
Locate the DIMMs on the ASR1000-RP2. See
Step 5
For the DIMM you want to remove, pull down the lever on the DIMM socket to release the DIMM from
Step 6
the socket. See
Figure 14-17
When one end of the DIMM is released from the socket, grasp each end of the DIMM with your thumb
Step 7
and forefinger and pull the DIMM completely out of the socket. Handle the edges of the DIMM only;
avoid touching the memory module or pins and the metal traces (the metal fingers along the connector
edge of the DIMM) along the socket edge.
Step 8
Place the DIMM in an antistatic bag to protect it from ESD damage.
Step 9
Repeat Step 5 through Step 8 for the remaining DIMMs if required for your upgrade.
This completes the steps for removing the Cisco ASR1000-RP2 DIMMs from the module.
Replacing the Cisco ASR1000-RP2 DIMMs
This section lists the steps to replace the Cisco ASR1000-RP2 DIMMs.
Step 1
Place the route processor on an antistatic mat or pad and ensure that you are wearing an antistatic device,
such as a wrist strap.
Position the route processor so that the faceplate is toward you and the edge connector is away from you.
Step 2
DIMMs are sensitive components that can be shorted by mishandling; they are susceptible to ESD
Caution
damage. Handle DIMMs by the edges only and avoid touching the pins.
Remove the new DIMM from the antistatic bag.
Step 3
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-26
Chapter 14
Figure
14-17.
DIMM Socket Release Lever to Remove the DIMM
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Figure
14-16, callout 2.
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router