Table of Contents
Advertisement
Removing and Replacing Cisco ASR 1000 Series Route Processor Internal Hard Drive
Replacing the Cisco ASR1000-RP1 Internal Hard Drive
To replace the Cisco ASR1000-RP1 internal hard drive and insert the Cisco ASR 1000 Series Route
Processor 1 into the Cisco ASR 1000 Series Router, follow these steps:
Step 1
On the Cisco ASR1000-RP1, carefully align the new hard drive unit with its screw fastener to the base
screw on the bottom of the module.
Step 2
Reconnect the two cables to the rear of the hard drive. These are keyed for easy connection.
Figure 14-5
Figure 14-5
1
Align hard drive module to carrier base tabs, align the module fastener to base screw mate by hand, and
Step 3
then tighten with screw driver.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-8
shows the Cisco ASR1000-RP1 module internal hard drive and module base.
Cisco ASR1000-RP1 Module Internal Hard Drive and Module Base
1
2
Hard drive module fastener
Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
2
Carrier mating fastener
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router