Table of Contents
Advertisement
Connecting a Terminal to the Cisco ASR 1000 Series RP Console Port
A crossover cable reverses pin connections from one end to the other. In other words, it connects pin 1
(at one end) to pin 8 (at the other end), pin 2 to pin 7, pin 3 to pin 6, and so on. You can identify a
crossover cable by comparing the two modular ends of the cable. Hold the cable ends in your hand,
side-by-side, with the tabs at the back. Ensure that the wire connected to the outside (left) pin of the left
plug (pin 1) is the same color as the wire connected to the outside (right) pin of the right plug (pin 8).
Use the following procedure to connect a video terminal to the console port on a route processor.
Each Cisco ASR 1000 Series Route Processor must have a console port connection (typically to a
Note
terminal server) if you are running a redundant configuration in the chassis.
Connect one end of the RJ-45 cables to the serial RJ-45 port (CON) on the Cisco ASR 1000 Series Route
Step 1
Processor 1 (see
Figure 6-25
1
CONsole port
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
6-34
Figure
6-25).
Console Port Connection on the ASR 1000 Series Route Processor
Chapter 6
Cisco ASR 1006 Router Overview and Installation
1
2
AUX
LIN K
CO N
ERN ET
MGM T ETH
CA RR IER
BIT S
AUX
LIN K
CO N
ERN ET
MGM T ETH
CA RR IER
BIT S
2
AUXiliary port
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router