Address-Range - Cisco ASR 9000 Series Command Reference Manual

Aggregation services router broadband network gateway

Hide thumbs Also See for ASR 9000 Series:

Table of Contents

address-range

To specify address range for allocation, use the address-range command in Pool IPv4 or IPv6 configuration

submode. To remove the address range, use the no form of this command.

address-range first_range last_range

no address-range first_range last_range

Syntax Description

Command Default

Command Modes

Pool IPv4 configuration

Pool IPv6 configuration

Command History

Release 4.2.0

Release 4.3.0

Usage Guidelines

You should only specify the addresses that are assignable to clients in a particular subnet. The interface and

broadcast addresses should not be included in the address-range configuration.

Use the pool ipv4 command to enter IPv4 pool configuration submode and pool ipv6 command to enter IPv6

pool configuration submode.

Multiple address-ranges are allowed within a pool.

Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,

Release 5.2.x

Specifies the first address in range from which the IP addresses can be assigned

Specifies the last address in range until which the IP addresses can be assigned

Modification

This command was introduced.

Support for IPv6 was added.

Address Pool Service Commands

Table of Contents