Show Dhcp Ipv6 Server Interface - Cisco ASR 9000 Series Command Reference Manual
Aggregation services router broadband network gateway
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
show dhcp ipv6 server interface
show dhcp ipv6 server interface
To display the server interface information for Dynamic Host Configuration Protocol (DHCP), use the show
dhcp ipv6 server interface command in EXEC mode.
show dhcp ipv6 server interface{type| interface-path-id} {location| location}
Syntax Description
type
interface-path-id
location
location
Command Default
None
Command Modes
EXEC mode
Command History
Release
Release 4.3.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
216
Interface type. For more information, use the question mark (?) online help function.
Either a physical interface instance or a virtual interface instance as follows:
• Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦ rack: Chassis number of the rack.
◦ slot: Physical slot number of the modular services card or line card.
◦ module: Module number. A physical layer interface module (PLIM) is always
0.
◦ port: Physical port number of the interface.
In references to a Management Ethernet interface located on a route processor
Note
card, the physical slot number is alphanumeric (RP0 or RP1) and the module
is CPU0. Example: interface MgmtEth0/RP1/CPU0/0.
• Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online help
function.
Displays the node location by Interface.
Displays the fully qualified location specification of an interface.
Modification
This command was introduced.
BNG DHCP Commands
Advertisement
Chapters
Table of Contents
