hit counter script

Interface-List - Cisco ASR 9000 Series Command Reference Manual

Aggregation services router broadband network gateway
Hide thumbs Also See for ASR 9000 Series:
Table of Contents

Advertisement

interface-list

interface-list
To configure the interface list (mapping list of all access ports) that are part of a specific subscriber redundancy
group (SRG), use the interface-list command in subscriber redundancy group configuration mode. To remove
the interface list configuration, use the no form of this command.
interface-list [interface interface-type interface-name {id interface-id| sub-if-range sub-if-start-range
sub-if-end-range id-range id-start-range id-end-range}]
no interface-list [interface interface-type interface-name {id interface-id| sub-if-range sub-if-start-range
sub-if-end-range id-range id-start-range id-end-range}]
Syntax Description
id
interface-id
sub-if-range
sub-if-start-range
sub-if-end-range
id-range
id-start-range
id-end-range
Command Default
None
Command Modes
Subscriber redundancy group configuration.
Command History
Release
Release 5.2.2
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
520
Specifies the mapping identifier of the interface-list.
The identifier for particular interface must be same on both master and slave
nodes.
Identifier value for the interface to be mapped on to the slave SRG.
Specifies the range of sub-interfaces to be added for the given interface.
Start value of sub-interface range.
The range is from 0 to 2147483647.
End value of sub-interface range.
The range is from 0 to 2147483647.
Specifies the range of interface-list identifiers.
Start ID of the interface to be mapped on to the SRG peer.
The range is from 1 to 65535.
End ID of the interface to be mapped on to the SRG peer.
The range is from 1 to 65535.
Modification
This command was introduced.
Subscriber Commands

Advertisement

Table of Contents
loading

Table of Contents

Save PDF