Show Pppoe Limits - Cisco ASR 9000 Series Command Reference Manual
Aggregation services router broadband network gateway
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
show pppoe limits
show pppoe limits
To show the PPPoE session limit information, use the show pppoe limits command in the EXEC mode mode.
show pppoe limits [active] [access-interface type interface-path-id | bba-group bba-group-name | location
node]
Syntax Description
active
access-interface
type
interface-path-id
bba-group
bba_group_name
location
node
Command Default
None
Command Modes
EXEC mode
Command History
Release
Release 4.2.0
Release 4.3.1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
466
Shows only those throttles that are currently blocking packets.
Shows PPPoE status for all sessions on a single access interface.
Interface type. For more information, use the question mark (?) online help
function.
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
Note
currently configured on the router.
For more information about the syntax for the router, use the question mark
(?) online help function.
Shows throttles for all interfaces with a given bba-group.
Specifies the bba-group to show throttle for.
Shows PPPoE status for all sessions at a location.
Specifies the fully qualified location specification.
Modification
This command was introduced.
The command output was extended for the session limits of mac
access-interface, mac-iwf access-interface, inner-vlan, outer-vlan, vlan
and circuit-id-and-remote-id
PPPoE Commands
Advertisement
Chapters
Table of Contents
