Inner-Cos - Cisco ASR 9000 Series Command Reference Manual
Aggregation services router broadband network gateway
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
BNG DHCP Commands
inner-cos
To reset the default inner-cos value for DHCPv4 control packets sent on BNG subscriber interfaces, use the
inner-cos command in DHCP IPv4 configuration mode. To set the inner-cos value back to the default value,
use the no form of this command.
inner-cos value
no inner-cos value
Syntax Description
value
Command Default
None
Command Modes
DHCP IPv4 configuration
Command History
Release
Release 4.3.2
Task ID
Task ID
ip-services
Examples
This example shows how to reset the default inner-cos value for DHCPv4 control packets sent on BNG
subscriber interfaces:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
RP/0/RSP0/CPU0:router(config-dhcpv4)# inner-cos 0
Related Commands
Command
outer-cos, on page 178
Value of inner-cos for DHCPv4 control packets.
The range is from 0 to 7.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
This command was introduced.
Operation
read, write
Description
Resets the default outer-cos value for DHCPv4 control packets sent
on BNG subscriber interfaces.
inner-cos
5.2.x
161
Advertisement
Chapters
Table of Contents
