Cisco ASR 1002-X Router Power Supplies
Management Ethernet Port Cable Connection
To comply with Class A emission requirements, a shielded Ethernet cable must be used for the
Caution
connection.
On the front panel of the router, the Management Ethernet port is labeled MGMT ETHERNET. To use
the Management Ethernet interface on the router, perform the following steps:
Step 1
Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port.
Step 2
Insert the other end of the RJ-45 cable to your management device or network.
Cisco ASR 1002-X Router Power Supplies
This section describes the Cisco ASR 1002-X Router power supplies and how to connect them:
•
•
•
Read the safety warnings before you begin.
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Never install an AC power module and a DC power module in the same chassis. Statement 1050
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
10-30
Connecting AC Input Power to Cisco ASR 1002-X Router, page 10-31
Connecting the –48 VDC Input Power to the Cisco ASR 1002-X Router, page 10-34
Connecting the +24 VDC Power Supply to the Router, page 10-36
Chapter 10
Cisco ASR 1002-X Router Overview and Installation
OL-13208-11