Sip General Configuration Menu - Cisco 7941G Administration Manual
For cisco unified communications manager 9.0 (sccp and sip)
Hide thumbs
Also See for 7941G:
- Administration manual (302 pages) ,
- User manual (132 pages) ,
- Phone manual (92 pages)
Table of Contents
Advertisement
SIP Configuration Menu for SIP Phones
SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable SIP parameters on the
phone. The following table describes the options in this menu.
Table 15: SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF
Register with Proxy
Register Expires
Phone Label
Enable VAD
Start Media Port
End Media Port
NAT Enabled
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
86
Description
Displays the CODEC to use when a call is
initiated. This value will always be set to
none.
Displays the configuration of the
out-of-band signaling for tone detection on
the IP side of a gateway. The Cisco Unified
IP Phone (SIP) supports out-of-band
signaling by using the AVT tone method.
This value will always be set to avt.
This value will always be set to Yes.
Displays the amount of time, in seconds,
after which a registration request expires.
Displays the text that is displayed on the
top right status line of the LCD on the
phone. This text is for end user display only
and has no effect on caller identification or
messaging. This value will always be set to
null.
This value is set to No by default.
Displays the start Real-Time Transport
Protocol (RTP) range for media.
Displays the end Real-Time Transport
Protocol (RTP) range for media.
Displays if Network Address Translation
(NAT) is enabled. This value will always
be set to false.
Cisco Unified IP Phone Settings
To Change
Display only. Cannot configure.
Display only. Cannot configure.
Display only. Cannot configure.
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
Display only. Cannot configure.
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
Display only. Cannot configure.
- Quick Links:
- Cisco Unified Ip Phone 7942G
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
