Cisco 7941G Administration Manual page 126
For cisco unified communications manager 9.0 (sccp and sip)
Hide thumbs
Also See for 7941G:
- Administration manual (302 pages) ,
- User manual (132 pages) ,
- Phone manual (92 pages)
Table of Contents
Advertisement
Network Configuration Menu
Option
IP Addressing Mode
Preference for Signaling
Auto IP Configuration
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
106
Description
Indicates the IP address version that the
phone uses during signaling with Cisco
Unified Communications Manager when
both IPv4 and IPv6 are available on the
phone.
Displays one of the following options on
the phone:
• Use System Default—The dual-stack
phone uses the default system
addressing
• IPv4—The dual-stack phone prefers
to establish a connection via an IPv4
address during a signaling event
• IPv6—The dual-stack phone prefers
to establish a connection via an IPv6
address during a signaling event
Default: Use System Default
Displays whether the auto configurations
is enabled or disabled on the phone.
The Auto IP Configuration setting along
with the DHCPv6 setting determine how
the IP Phone obtains its IPv6 address and
other network settings. For more
information on how these two settings
affect the network settings on the phone,
see
DHCPv6 and Autoconfiguration, on
page
83.
Note
Use the "Allow
Auto-Configuration for Phones"
setting in Cisco Unified
Communications Manager
Administration.
Cisco Unified IP Phone Settings
To Change
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > Common
Device Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > Common
Device Configuration.
- Quick Links:
- Cisco Unified Ip Phone 7942G
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
