Phone Startup Process Verification - Cisco 7941G Administration Manual
For cisco unified communications manager 9.0 (sccp and sip)
Hide thumbs
Also See for 7941G:
- Administration manual (302 pages) ,
- User manual (132 pages) ,
- Phone manual (92 pages)
Table of Contents
Advertisement
Phone Startup Process Verification
Phone Startup Process Verification
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by cycling
through the following steps.
1 These buttons flash on and off in sequence:
2 Some or all of the line keys flash amber in sequence.
Caution
If the line keys flash red in sequence after flashing amber, do not power down the phone until the sequence
of red flashes completes. This sequence can take several minutes to complete.
3 Some or all of the line keys flash green.
Normally, this sequence takes just a few seconds. However, if the phone's Flash memory is erased or the
phone load is corrupted, the sequence of green flashes will continue while the phone begins a software
update procedure. If the phone performs this procedure, the following buttons light to indicate progress:
4 The phone screen displays the Cisco Systems, Inc., logo screen.
5 These messages appear as the phone starts:
6 The phone screen displays:
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
56
• Headset (only if the handset is off-hook when the phone powers up. Hang up the handset within 3
seconds to have the phone launch its secondary load. To continue with the primary load, leave the
handset off-hook.)
• Mute
• Speaker
• Headset—Phone is waiting for the network and completing CDP and DHCP configuration. A DHCP
server must be available in your network.
• Mute—Phone is downloading images from the TFTP server.
• Speaker—Phone is writing images to its Flash memory.
• Verifying Load (if the phone load does not match the load on the TFTP server). If this message
appears, the phone starts up again and repeats step 1 through step 4 above.
• Configuring IP
• Updating the Trust List
• Updating Locale
• Configuring Unified CM List
• Registering
• Current date and time
• Primary directory number
Cisco Unified IP Phones Installation
- Quick Links:
- Cisco Unified Ip Phone 7942G
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
