Sip General Configuration Menu - Cisco 7942G Administration Manual

Unified ip phone for cisco unified communications manager 6.1(3)

Hide thumbs Also See for 7942G:

Phone manual (98 pages)

User manual (23 pages)

Installation manual (12 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

134

135

136

137

138

139

140

141

142

143

144

145

146

147

148

149

150

151

152

153

154

155

156

157

158

159

160

161

162

163

164

165

166

167

168

169

170

171

172

173

174

175

176

177

178

179

180

181

182

183

184

185

186

187

188

189

190

191

192

193

194

195

196

197

198

199

200

201

202

203

204

Table of Contents

Chapter 4

Configuring Settings on the Cisco Unified IP Phone

SIP General Configuration Menu

The SIP General Configuration menu displays information about the configurable SIP parameters on the

phone.

Table 4-6

SIP General Configuration Menu Options

Option

Preferred CODEC

Out of Band DTMF

Phone Label

Enable VAD

Start Media Port

End Media Port

NAT Enabled

NAT Address

Call Statistics

Related Topics

•

Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)

OL-17679-01

Table 4-6

describes the options in this menu.

Description

Displays the CODEC to use when a call is initiated. This

value will always be set to none.

Displays the configuration of the out-of-band signaling

(for tone detection on the IP side of a gateway). The

Cisco Unified IP phone (SIP) supports out-of-band

signaling by using the AVT tone method. This value will

always be set to avt.

Displays if the phone must register with a proxy server

during initialization. This value will always be set to Yes.

Displays the amount of time, in seconds, after which a

registration request expires.

Displays the text that is displayed on the top right status

line of the LCD on the phone. This text is for end-user

display only and has no effect on caller identification or

messaging. This value will always be set to null.

This value is set to No by default.

Displays the start Real-Time Transport Protocol (RTP)

range for media.

Displays the end Real-Time Transport Protocol (RTP)

range for media.

Displays if Network Address Translation (NAT) is

enabled. This value will always be set to false.

Displays the WAN IP address of the NAT or firewall

server. This value will always be set to null.

This value is set to No by default.

Displaying a Configuration Menu, page 4-2

Device Configuration Menu

To Change

Display only—cannot configure.

From Cisco Unified

Communications Manager