Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Command
Step 3
snmp-server host ip-address traps snmp
vlan-membership
Example:
Router(config)# snmp-server host
172.16.128.263 traps1 snmp vlancommunity1
Step 4
end
Example:
Router(config)# end
Verifying Trap Managers
Use the show running-config command to verify that the information was entered correctly by
displaying the running configuration:
Router# show running-config
Configuring IP Information
This section describes how to assign IP information on the HWICs. The following topics are included:
•
•
Assigning IP Information to the Switch
You can use a BOOTP server to automatically assign IP information to the switch; however, the BOOTP
server must be set up in advance with a database of physical MAC addresses and corresponding IP
addresses, subnet masks, and default gateway addresses. In addition, the switch must be able to access
the BOOTP server through one of its ports. At startup, a switch without an IP address requests the
information from the BOOTP server; the requested information is saved in the switch running the
configuration file. To ensure that the IP information is saved when the switch is restarted, save the
configuration by entering the write memory command in privileged EXEC mode.
You can change the information in these fields. The mask identifies the bits that denote the network
number in the IP address. When you use the mask to subnet a network, the mask is then referred to as a
subnet mask. The broadcast address is reserved for sending messages to all hosts. The CPU sends traffic
to an unknown IP address through the default gateway.
Follow these steps to enter the IP information.
SUMMARY STEPS
1.
2.
3.
4.
5.
Assigning IP Information to the Switch, page 93
Specifying a Domain Name and Configuring the DNS, page 95
enable
configure terminal
interface vlan_id
ip address ip-address subnet-mask
exit
Purpose
Enters the trap manager IP address, community string, and the
traps to generate.
Returns to privileged EXEC mode.
How to Configure EtherSwitch HWICs
Book Title
93
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
