Table of Contents
Advertisement
How to Configure EtherSwitch HWICs
Enter the show vlan-switch brief command in EXEC mode, using the Cisco IOS CLI to verify that a
VLAN has been deleted from the switch, as shown in the following output example:
Router# show vlan-switch brief
VLAN Name
---- -------------------------------- --------- -------------------------------
1
300
1002 fddi-default
1003 token-ring-default
1004 fddinet-default
1005 trnet-default
Router#
Configuring VLAN Trunking Protocol
This section describes how to configure the VLAN Trunking Protocol (VTP) on an EtherSwitch HWIC,
and contains the following tasks:
•
•
•
•
VTP pruning is not supported by EtherSwitch HWICs.
Note
Configuring a VTP Server
When a switch is in VTP server mode, you can change the VLAN configuration and have it propagate
throughout the network.
Follow the steps below to configure the switch as a VTP server.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
Book Title
10
default
VLAN0300
Configuring a VTP Server, page 10
Configuring a VTP Client, page 12
Disabling VTP (VTP Transparent Mode), page 12
Verifying VTP, page 13
enable
vlan database
vtp server
vtp domain domain_name
vtp password password_value
exit
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Status
Ports
active
Fa0/1/0, Fa0/1/1, Fa0/1/2
Fa0/1/3, Fa0/1/4, Fa0/1/5
Fa0/1/6, Fa0/1/7, Fa0/1/8
active
active
active
active
active
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
