Table of Contents
Advertisement
How to Configure EtherSwitch HWICs
Command
Step 5
show running-config
Example:
Router# show running-config
Step 6
copy running-config startup-config
Example:
Router# copy running-config
startup-config
To return to the default aging-time interval, use the no bridge bridge-group aging-time global
configuration command.
Filtering Frames by a Specific MAC Address
A switch examines frames and sends them through the internetwork according to the destination address;
a switch does not forward a frame back to its originating network segment. You can use the software to
configure specific administrative filters that filter frames based on information other than the paths to
their destinations.
You can filter frames with a particular MAC-layer station destination address. Any number of addresses
can be configured in the system without a performance penalty.
Follow the steps below to filter by the MAC-layer address.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Book Title
78
enable
configure terminal
bridge bridge-group address mac-address {forward | discard} [interface-id]
end
show running-config
copy running-config startup-config
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Verifies your entry.
(Optional) Saves your entry in the configuration file.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
