Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
no ip address
end
Use the show interfaces command to verify the switchport configuration of the interface, as shown
below.
Router# show interfaces f0/1/0 switchport
Name: Fa0/1/0
Switchport: Enabled
Administrative Mode: static access
Operational Mode: static access
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: native
Negotiation of Trunking: Disabled
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: ALL
Trunking VLANs Active: 1
Priority for untagged frames: 0
Override vlan tag priority: FALSE
Voice VLAN: none
Appliance trust: none
Router#
Configuring 802.1x Authentication
This section describes how to configure 802.1x port-based authentication on an EtherSwitch HWIC:
•
•
•
•
•
•
•
•
•
•
Information About the Default 802.1x Configuration
Table 1
Enabling 802.1x Authentication, page 25
Enabling Periodic Reauthentication, page 28
Changing the Quiet Period, page 29
Enabling Multiple Hosts, page 33
shows the default 802.1x configuration.
How to Configure EtherSwitch HWICs
Book Title
23
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
