Table of Contents
Advertisement
How to Configure EtherSwitch HWICs
4.
5.
6.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
no bridge bridge-group acquire
Example:
Router(config)# no bridge 100
acquire
Step 4
end
Example:
Router(config)# end
Step 5
show running-config
Example:
Router# show running-config
Step 6
copy running-config startup-config
Example:
Router# copy running-config
startup-config
To cause the switch to forward frames to stations that it has dynamically learned, use the bridge
bridge-group acquire global configuration command.
Book Title
76
end
show running-config
copy running-config startup-config
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enables the switch to stop forwarding any frames for stations that it has
dynamically learned through the discovery process and to limit frame
forwarding to statically configured stations.
•
The switch filters all frames except those whose destined-to
addresses have been statically configured into the forwarding
cache. To configure a static address, use the bridge bridge-group
address mac-address {forward | discard} global configuration
command.
For bridge-group, specify the bridge group number. The range is 1
•
to 255.
Returns to privileged EXEC mode.
Verifies your entry.
(Optional) Saves your entry in the configuration file.
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
