Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Command
Step 5
end
Example:
Router(config-if)# end
Step 6
show power inline
Example:
Router# show power inline
Example
Use the show power inline command to verify the power configuration on the ports, as illustrated below.
Router# show power inline
PowerSupply
-----------
INT-PS
Interface
---------
Fa0/1/0
Fa0/1/1
Fa0/1/2
Fa0/1/3
Fa0/1/4
Fa0/1/5
Fa0/1/6
Fa0/1/7
Fa0/3/0
Fa0/3/1
Fa0/3/2
Fa0/3/3
Fa0/3/4
Fa0/3/5
Fa0/3/6
Fa0/3/7
Configuring IP Multicast Layer 3 Switching
These sections describe how to configure IP multicast Layer 3 switching:
•
•
•
•
Enabling IP Multicast Routing Globally
You must enable IP multicast routing globally before you can enable IP multicast Layer 3 switching on
Layer 3 interfaces.
SlotNum.
Maximum
--------
-------
0
120.000
Config
Phone
------
-----
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
Enabling IP Multicast Routing Globally, page 57
Enabling IP Protocol-Independent Multicast (PIM) on Layer 3 Interfaces, page 59
Verifying IP Multicast Layer 3 Hardware Switching Summary, page 60
Verifying the IP Multicast Routing Table, page 61
Purpose
Returns to privileged EXEC mode.
Displays power configuration on the ports.
Allocated
Status
---------
------
101.500
PS GOOD
Powered
PowerAllocated
-------
--------------
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
Cisco
On
IEEE-2
On
Cisco
On
How to Configure EtherSwitch HWICs
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
6.300 Watts
7.000 Watts
6.300 Watts
Book Title
57
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
