Table of Contents
Advertisement
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
The following example shows how to change to the interface-range configuration mode using the
interface-range macro enet_list:
Router(config)# interface range macro enet_list
Optional Interface Feature: Examples
•
•
•
Interface Speed: Example
The following example shows the interface speed being set to 100 Mbps on Fast Ethernet interface 0/3/7:
Router(config)# interface fastethernet 0/3/7
Router(config-if)# speed 100
Setting the Interface Duplex Mode: Example
The following example shows the interface duplex mode being set to full on Fast Ethernet interface
0/3/7:
Router(config)# interface fastethernet 0/3/7
Router(config-if)# duplex full
Adding a Description for an Interface: Example
The following example shows how to add a description of Fast Ethernet interface 0/3/7:
Router(config)# interface fastethernet 0/3/7
Router(config-if)# description Link to root switch
Stacking: Example
The following example shows how to stack two HWICs.
Router(config)# interface FastEthernet 0/1/8
Router(config-if)# no shutdown
Router(config-if)# switchport stacking-partner interface FastEthernet 0/3/8
Router(config-if)# interface FastEthernet 0/3/8
Router(config-if)# no shutdown
Note
In practice, the command switchport stacking-partner interface FastEthernet
0/partner-slot/partner-port needs to be executed for only one of the stacked ports. The other port will be
automatically configured as a stacking port by the Cisco IOS software. The command no shutdown,
however, must be executed for both of the stacked ports.
Interface Speed: Example, page 107
Setting the Interface Duplex Mode: Example, page 107
Adding a Description for an Interface: Example, page 107
Configuration Examples for EtherSwitch HWICs
Book Title
107
- Quick Links:
- Configuring Vlans
Hide quick links:
Advertisement
Chapters
Table of Contents
