Cli-Console-Timeout - Siemens SCALANCE XC-200 Configuration Manual
Simatic net command line interface industrial ethernet switches
Hide thumbs
Also See for SCALANCE XC-200:
- Configuration manual (270 pages) ,
- Operating instructions manual (84 pages) ,
- Set up and configuration (64 pages)
Table of Contents
Advertisement
Parameter
port-channel
port-channel-id
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 36)".
Result
The logical interface is deleted.
Further notes
You configure an interface with the interface command.
You display the status and the configuration of the interfaces with the show interfaces
command.
3.1.9.3
cli-console-timeout
Description
With this command, you enable the automatic logout and you configure the timeout setting for
the CLI.
Note
No automatic logout from the CLI
If the connection is not terminated after the set time, check the setting of the "keepalive"
function on the Telnet client. If the set interval is shorter than the configured time, the lower
value applies. You have set, for example, 300 seconds for the automatic logout and 120
seconds for the "keepalive" function. In this case, a packet is sent every 120 seconds that
keeps the connection up.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
cli-console-timeout [seconds(60-600)]
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a port channel connection
Number of the addressed port channel
Configuration
3.1 System
Range of values / note
-
1 ... 8
67
Hide quick links:
Advertisement
Table of Contents
