Poe; The "Show" Commands; Show Poe Status - Siemens SCALANCE XC-200 Configuration Manual

Simatic net command line interface industrial ethernet switches

Hide thumbs Also See for SCALANCE XC-200:

Table of Contents

Configuration

3.5 PoE

This section describes commands with which you display various settings.

This command shows specific information for all or for a selected PoE interface (PoE: Power

over Ethernet).

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

cli> or cli#

Call up the command with the following parameters:

show poe status [interface <interface-type> <interface-id>]

The parameters have the following meaning:

interface-type

interface-id

If you use the command without setting parameters, information about all PoE interfaces is

For information on names of addresses and interfaces, refer to the section "Addresses and

interface names (Page 36)".

The information for the selected PoE interface is displayed.

Keyword for a an interface description

Type or speed of the interface

Module no. and port no. of the interface

SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface

Range of values / note

Enter a valid interface.

Configuration Manual, 07/2017, C79000-G8976-C361-06

Show Quick Links

Table of Contents