Network - Siemens SCALANCE XC-200 Configuration Manual

Simatic net command line interface industrial ethernet switches

Hide thumbs Also See for SCALANCE XC-200:

Table of Contents

You are in the DHCPPOOL configuration mode.

The command prompt is as follows:

cli(config-dhcp-pool-<ID>)#

Call up the command with the following parameters:

lease-time <seconds (60-31536000)>

The parameter has the following meaning:

The time is configured.

Further notes

You display the setting with the show ip dhcp-server pools command.

network

With this command you configure the IPv4 address band from which the DHCP client receives

any IPv4 address.

Assignment of IP addresses

When assigning IP addresses from a local address band, the IPv4 address of the interface

must be located within the IPv4 address band. If this is not the case, the interface does not

assign any IPv4 addresses.

The IP address does not need to be within the IPv4 address band if relay agent information is

configured for the address band.

You are in the DHCPPOOL configuration mode.

The command prompt is as follows:

SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface

Configuration Manual, 07/2017, C79000-G8976-C361-06

Time until renewal of the assigned

IPv4 address in seconds

Network protocols

7.3 DHCP server

Range of values / note

60 ... 31536000

Show Quick Links

Table of Contents