No Ip Dhcp Relay Remote-Id - Siemens SCALANCE XC-200 Configuration Manual
Simatic net command line interface industrial ethernet switches
Hide thumbs
Also See for SCALANCE XC-200:
- Configuration manual (270 pages) ,
- Operating instructions manual (84 pages) ,
- Set up and configuration (64 pages)
Table of Contents
Advertisement
Network protocols
7.4 DHCP Relay
Requirement
● The interface is an IP interface.
● You are in the Interface Configuration mode of VLAN. The command prompt is as follows:
cli(config-if-vlan-$$)#
Syntax
Call up the command with the following parameters:
ip dhcp relay remote-id <remote-id name>
The parameter has the following meaning:
Parameter
remote-id name
Result
The device ID is specified.
Further notes
You remove the device ID with the no ip dhcp relay remote-id command.
You display the IP addresses with the show dhcp server command.
You display the settings with the show ip dhcp relay information command.
7.4.3.4
no ip dhcp relay remote-id
Description
With this command, you remove the device identifier.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay remote-id
320
Description
Device ID
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
max. 32 characters
Default: XYZ
Configuration Manual, 07/2017, C79000-G8976-C361-06
Hide quick links:
Advertisement
Table of Contents
