No Cos-Remap; Cos-Remap-Enable - Siemens SCALANCE XC-200 Configuration Manual
Simatic net command line interface industrial ethernet switches
Hide thumbs
Also See for SCALANCE XC-200:
- Configuration manual (270 pages) ,
- Operating instructions manual (84 pages) ,
- Set up and configuration (64 pages)
Table of Contents
Advertisement
Load control
10.5 Service classes
10.5.3.7
no cos-remap
Description
With this command, you reset the send priority back to the default value.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call the command without parameters:
no cos-remap
Result
The send priorities are reset to the default value.
Further notes
You change the send priority depending on the priority when receiving a frame with the cos-
remap command.
You enable the the CoS reassignment with the cos-remap-enable command.
You disable the the CoS reassignment with the no cos-remap-enable command.
You display the assignment table for the send priority with the show qos cos-remap
command.
10.5.3.8
cos-remap-enable
Description
With this command, you enable the CoS reassignment function. Depending on the priority
when receiving a frame, you can change the priority with which it is sent.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
490
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Hide quick links:
Advertisement
Table of Contents
