Cos-Remap - Siemens SCALANCE XC-200 Configuration Manual

Simatic net command line interface industrial ethernet switches

Hide thumbs Also See for SCALANCE XC-200:

Table of Contents

cos-remap

With this command depending on the priority when receiving a frame, you can change the

priority with which it is sent.

You are in the QOS configuration mode.

The command prompt is as follows:

cli(config-qos)#

Call up the command with the following parameters:

cos-remap interface <interface-type><interface-id> <prio (0-7)>

The parameters have the following meaning:

interface-type

interface-id

remapped prio

The send priority has been changed.

Further notes

You reset the send priority to the default value with the no cos-remap command.

You enable the CoS reassignment with the cos-remap-enable command.

You disable the the CoS reassignment with the no cos-remap-enable command.

You display the assignment table for the send priority with the show qos cos-remap

SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface

Configuration Manual, 07/2017, C79000-G8976-C361-06

Keyword for a an interface description

Type or speed of the interface

Module no. and port no. of the interface

Priority with which a frame is received.

Priority with which a frame will be sent

Load control

10.5 Service classes

Range of values / note

Enter a valid interface

Show Quick Links

Table of Contents