Show Mac-Address-Table Dynamic Unicast - Siemens SCALANCE XC-200 Configuration Manual
Simatic net command line interface industrial ethernet switches
Hide thumbs
Also See for SCALANCE XC-200:
- Configuration manual (270 pages) ,
- Operating instructions manual (84 pages) ,
- Set up and configuration (64 pages)
Table of Contents
Advertisement
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The dynamic multicast MAC addresses are displayed.
6.1.1.4
show mac-address-table dynamic unicast
Description
This command shows the table with the dynamic unicast MAC addresses assigned by the
device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Network structures
6.1 VLAN
Range of values / note
-
1 ... 4094
Enter the range limits with a hy‐
phen without spaces.
-
-
-
Enter a valid interface
165
Hide quick links:
Advertisement
Table of Contents
