Ppp Timeout Retry - Cisco ASR 9000 Series Command Reference Manual

Aggregation services router

Hide thumbs Also See for ASR 9000 Series:

Table of Contents

ppp timeout retry

To set PPP timeout retry parameters, use the ppp timeout retry command in interface configuration mode.

To reset the time value, use the no form of this command.

ppp timeout retry seconds

no ppp timeout retry

Syntax Description

Command Default

Command Modes

Interface configuration

Command History

Release 3.9.0

Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes appropriate task

IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator

for assistance.

The ppp timeout retry command is useful for setting a maximum amount of time PPP should wait for a

response to any control packet it sends.

The following example shows the retry timer being set to 8 seconds:

RP/0/RSP0/CPU0:router# configure

RP/0/RSP0/CPU0:router(config)# interface POS 0/3/0/1

RP/0/RSP0/CPU0:router(config-if)# encapsulation ppp

RP/0/RSP0/CPU0:router(config-if)# ppp timeout retry 8

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x

Maximum time, in seconds, to wait for a response during PPP negotiation. Range is

from 1 to 10 seconds. Default is 3 seconds.

Modification

This command was introduced.

PPP Commands onthe Cisco ASR 9000 Series Router

Show Quick Links

Table of Contents