Oam Protocol Cfm Svlan - Cisco ME 3800X Command Reference Manual
Hide thumbs
Also See for ME 3800X:
- Installation manual (80 pages) ,
- Software manual (956 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
oam protocol cfm svlan
oam protocol cfm svlan
To configure the Ethernet virtual connection (EVC) operation, administration, and maintenance (OAM)
protocol as IEEE 801.2ag Connectivity Fault Management (CFM) and to identify the service provider
VLAN-ID for a CFM domain level, use the oam protocol cfm svlan command in EVC configuration
mode. To remove the OAM protocol configuration for the EVC, use the no form of this command.
Syntax Description
vlan-id
domain domain-name
Defaults
There are no service provider VLANs identified for an EVC.
Command Modes
EVC configuration
Command History
Release
12.2(52)EY
Usage Guidelines
When you enter domain domain-name, the CFM domain must have already been created by entering the
ethernet cfm domain domain-name level level-id global configuration command. If the CFM domain
does not exist, the command is rejected, and an error message appears.
Examples
This example shows how to enter EVC configuration mode and to configure the OAM protocol as CFM:
Switch(config)# ethernet evc test1
Switch(config-evc)# oam protocol cfm svlan 22 domain Operator
Related Commands
Command
ethernet evc evc-id
ethernet cfm domain
Cisco ME 3800X and ME 3600X Switch Command Reference
2-200
oam protocol cfm svlan vlan-id domain domain-name
no oam protocol
Service provider VLAN ID for CFM. The range is 1 to 4094.
Identifies the CFM domain for the service provider VLAN ID. If the CFM
domain does not exist, the command is rejected, and an error message
appears.
Modification
This command was introduced.
Description
Defines an EVC and enters EVC configuration mode.
Defines a CFM domain and sets the domain level.
Chapter 2
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
OL-28238-01
Advertisement
Table of Contents
