Privileged Exec Mode - Cisco ME 3800X Command Reference Manual
Hide thumbs
Also See for ME 3800X:
- Installation manual (80 pages) ,
- Software manual (956 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
CLI Command Modes
Interface Configuration Mode
Interface configuration commands modify the operation of the interface. Interface configuration
commands always follow a global configuration command, which defines the interface type.
Use the interface interface-id command to access interface configuration mode. The new prompt means
interface configuration mode.
Switch(config-if)#
The supported commands can vary depending on the version of software in use. To display a
comprehensive list of commands, enter a question mark (?) at the prompt.
Switch(config-if)# ?
To exit interface configuration mode and to return to global configuration mode, enter the exit command.
To exit interface configuration mode and to return to privileged EXEC mode, enter the end command,
or press Ctrl-Z.
VLAN Configuration Mode
Use this mode to configure normal-range VLANs (VLAN IDs 1 to 1005) or extended-range VLANs
(VLAN IDs 1006 to 4094). The VLAN configuration is saved in the running configuration file, and you
can save it to the switch startup configuration file by using the copy running-config startup-config
privileged EXEC command. The configurations of VLAN IDs 1 to 1005 are saved in the VLAN
database. The extended-range VLAN configurations are not saved in the VLAN database.
Enter the vlan vlan-id global configuration command to access VLAN configuration mode:
Switch(config)# vlan 2000
Switch(config-vlan)#
To display a comprehensive list of available commands, enter a question mark (?) at the prompt.
Switch(config-vlan)# ?
For extended-range VLANs, many characteristics are not configurable and must remain at the default
setting.
To return to global configuration mode, enter exit; to return to privileged EXEC mode, enter end. All
the commands except shutdown take effect when you exit config-vlan mode.
Line Configuration Mode
Line configuration commands modify the operation of a terminal line. Line configuration commands
always follow a line command, which defines a line number. Use these commands to change terminal
parameter settings line-by-line or for a range of lines.
Use the line vty line_number [ending_line_number] command to enter line configuration mode. The
new prompt means line configuration mode. The following example shows how to enter line
configuration mode for virtual terminal line 7:
Switch(config)# line vty 0 7
The supported commands can vary depending on the version of software in use. To display a
comprehensive list of commands, enter a question mark (?) at the prompt.
Switch(config-line)# ?
Cisco ME 3800X and ME 3600X Switch Command Reference
1-4
Chapter 1
Using the Command-Line Interface
OL-28238-01
Advertisement
Table of Contents
