Network-Clock Input-Source - Cisco ME 3800X Command Reference Manual

Hide thumbs Also See for ME 3800X:

Table of Contents

Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands

network-clock input-source

To configure the Synchronous Ethernet (SyncE) input clock and priority, use the network-clock

input-source command in global configuration mode. To remove the priority, use the no form of this

Syntax Description

The SyncE network clock is not configured.

Command Modes

Global configuration

Command History

Usage Guidelines

During operation, the system selects the network clock based on the priority.

Example 1 - SYNCE as Clock Source

The following example shows how to configure SyncE as the network clock input source.

Switch(config)# network-clock input-source 1 interface tenGigabitEthernet ?

<0-0> TenGigabitEthernet interface number

network-clock input-source priority [external] [interface]

no network-clock input-source priority [external] [interface]

Sets the priority of the device as a network clock. The range is from 1 to

250, with 1 being the highest priority. Unused network clocks are given

a priority value of 0.

Modification

This command was introduced.

Specifies the type of external interface:

Specifies the type of interface:

Cisco ME 3800X and ME 3600X Switch Command Reference

network-clock input-source